Teach you step by step to replace the iphone 6 battery

Iphone 6 battery using the 300-500 cycle charge, it will be 80% of the remaining power, this will undoubtedly greatly reduce the iphone 6 battery life, therefore, replacement iphone 6 battery has become the best choice, which is the most Cost-effective solution. If you replace iphone 6 battery, the following replacement steps will undoubtedly help you!

Replacement before preparation:

1. iphone 6 replacement battery, you can directly access mpbatt.com, buy high quality, low price iphone 6 replacement battery.

2.Repair Fix Kit, Buy Now

1, first turn off the machine, and then use a screwdriver to remove the bottom two fixed screws

2, the screw removed, the use of ready to open the screen to help open the screen

3, because the edge of the screen 6 did not use glue, so the screen is easy to open

4, opened the screen slowly from the bottom to the top of the open

5, the screen erected 90 degrees, and then find a fixed thing, with rubber band fixed live

6, if the veteran can directly replace the battery, wireless dismantling the screen

7, and then remove the power supply btb fixed cover screws

8, with a tweezers to remove the fixed cover

9, with a pry bar to btb disconnect

10, then remove the screen btb to secure the cover screws, and then remove the cover

11, with a pry bar to disconnect the screen cable one by one

12, with a pry bar to disconnect the screen cable one by one

13, so that the screen can be successfully separated

14, then twist the bottom of the battery with tweezers easy to pull tape

15, hand pull the tape one by one pull out

16, hand pull the tape one by one pull out

17, hand pull the tape one by one pull out

18, to be easy to pull the tape all pull out the battery can be easily removed, and if the easy to pull the tape pull off the use of plastic sheeting pry out

19, the new battery paste into the battery into the battery slot

20, the screen cable one by one on the buckle

21, and then install a fixed cover and screws

22, the power supply btb buckle and put on the fixed cover and screws

23, the top of the screen first into the fuselage, and then slowly close

24, pay attention to the screen must be closed from the top

25, and then slowly cover the screen, cover carefully press the lower edge, so that they are homing to the correct location

26, and finally put the bottom two fixed screw boot can be used normally. (Note that the battery must be installed after the test and then sealed, to avoid problems caused by the second disassemble unnecessary trouble)

These are the replacement of iphone 6 battery the whole process